Installation Guide

Safety instructions
WARNING: INTENDEDUSE
The VTAP100 equipment is intended for use by suitably qualified integrators, who will
integrate the VTAP100 OEM module (PCB) into their own hardware, without any changes or
modifications to the VTAP100 OEM module device. (An optional wallbox case can be
supplied.) Components mounted on the VTAP100 PCB are not user-serviceable. Product
safety has been tested to comply with IEC 62368-1.
WARNING: ESD PRECAUTIONS
We recommend careful handling and storage of Electrostatic Sensitive Devices (ESDs) during
installation. The VTAP100 OEM module (PCB) should always be protected by static shielding
bags for shipping or storage.
WARNING: POWERSUPPLY
Use only a MicroUSB to USB cable, or the optional captive USB cable, if any, to connect the
VTAP100 OEM module PCB to a PC. (Never connect both at the same time).
Using other cables will invalidate EMC emissions and immunity certifications.
The VTAP100 is rated at 5V DC (typ. 110mA, max 150mA) for power over USB.
VTAP100 OEM MODULE INSTALLATION GUIDE PAGE II