Instruction Manual

1514
• Do not expose the units to microwave
radiantion. The lithium battery may explode!
• Keep these devices and the batteries out
of reach of children.
• Batteries contain harmful acids and may be
hazardous if swallowed. If a battery is
swallowed, this can lead to serious internal
burns and death within two hours.
If you suspect a battery could have been
swallowed or otherwise caught in the body,
seek medical help immediately.
• Batteries must not be thrown into a re,
short-circuited, taken apart or recharged.
Risk of explosion!
• Low batteries should be changed as soon
as possible to prevent damage caused
by leaking. Never use a combination of old
and new batteries together, nor batteries of
 di󰀨erenttypes.
• Wear chemical-resistant protective gloves
and safety glasses when handling l e ak in g
batteries.
MATERIAL SUPPLIED
This package contains:
1 x PH CHECK, 2 X CR2032 button battery,
1 x Operation manual and
1 x Container with storage solution
POWER SUPPLY
Loose the battery cover in clockwise
direction by coin, remove the battery stripe
(DON‘T discard the washer!)
Put back the battery cover and turn it in
counter-clockwise direction to lock.
The meter is powered by 2 pcs CR2032 batteries.
To check the battery when:
1. The battery symbol appears on LCD
2. The meter can not power on
To install the batteries:
1.Turno󰀨themeter.
2. Loose the battery cover in clockwise
LCD DISPLAY
- The 1st display shows the measured pH
reading.
- The 2nd display shows the temp.
- Cal = Calibration mode
- ATC = Auto Temp. Compensation
-
=Data hold
direction by coin (DON‘T discard the washer!)
3. Replace the old batteries with two new
button cells CR2032.
4. Make sure the batteries are in place and the
polarity is correct.
5. Put back the battery cover and turn it in
counter-clockwise direction to lock
NOTE:
1. Please re-calibrate the meters after
changing batteries.
2. Remove battery from instruments that
you do not plan to use for a month or more.
Do not leave battery in instrument.