Manualshelf

User manual

ManualsBrandsDOSTMANN ELECTRONIC ManualsTest & Measurement AccessoriesSoftware with USB-cable SoftwareCompatible with LOG100, LOG110
12345678910
9Introduction
DE Dostmann Electronic GmbH
2.6 First connection of a device
To commission the logger, proceed as described in the instruction manual (insert
the battery or remove the protective film). The logger is ready to operate and can
be connected to the PC.
Connect the logger to the PC via the USB connection cable.
When you connect the logger for the first time, there no drivers available. When the
computer is on or after connecting the logger, the operating system detects a "new
unknown hardware" and wants to install the necessary drivers. They are on the CD
or, if the software has already been installed, in the folder "Drivers" of the program
directory where the software was installed.
For this purpose, proceed as described in "Installing the USB driver".
Installing the drivers and the software
2.7 Installing the Log-Graph software
The Log-Graph software is delivered on CD or its newest version can be
downloaded from the Internet. To operate the logger on the PC, a driver that must be
installad prior to software operation in order for the software to function properly with
the logger, is necessary. The driver is also located on the CD.
If no logger 100/110 has previously been connected to the PC, the drivers first must
be installed.
2.7.1 Installing the CD
a) Insert the CD into your drive and close the drive door. With most systems, the CD
is automatically detected and the installation routine starts. If this is not the case,
launch the installation via the taskbar by using the sequence Start-> Run-> [Your CD
drive] -> Menu.exe.
b) Now, follow the instructions of the installation routine. During installation, a target
directory Programs\Log-Graph that can be changed if necessary is proposed to you.
c) The installation process creates a program group for the selected directory on
your PC and a program icon called "Log-Graph".
d) For a subsequent run, launch the program, for example, by double-clicking on the
program icon "Log-Graph" on the desktop or by using the sequence Start->
Programs-> [Selection: Log-Graph] -> Mouse click.