User manual
70 LogGraph
DE Dostmann Electronic GmbH
Self-created headers are accepted by the device file created initially (if created) and may be
edited before printing. The printout can be left-aligned, right-aligned or centered on the page.
WARNING!
If there are many thousands of records, many hundreds of pages could also be printed. The
number of records or the number of pages may therefore be limited. To avoid accidental
printing of a large number of pages, a warning/confirmation message appears when there
are more than two pages.
Selecting the records
If measurement series are to be printed, the number of records can be restricted. To this
end, a selection of records can be made by entering the first and last record or the number
of pages is limited according to data before starting printing.
Pages to be printed
Once the graph and records have been selected, the number of pages required for printing is
calculated and displayed. By limiting the number of pages, the number of records (initial and
final value) is automatically corrected and displayed for control purposes. Individual pages
can also be printed.
Configure
With "Configure", the options available on the printer may be adapted to printing. These are,
eg, the paper size (portrait / landscape), the printer resolution and quality or the number of
copies. The options available depend on the capabilities of the printer driver installed.
However, it is possible that all the capabilities of your printer driver are not used when
printing via Log-Graph.
Print
"Print" allows you to start printing using the settings previously made. If there are more than
two pages, a security question appears asking you if you really want to print the page
number indicated.
Cancel
" Cancel" allows you to quit the print dialog and return to the starting point without any
further operation.
The first page of the printed form has, for example, the following appearance, after
selecting the options "Print the graph and records", "Use the screen display", "Print
with grid lines":