User manual

4 LogGraph
DE Dostmann Electronic GmbH
The connection of the logger to the PC is made, using an appropriate USB cable
plugged into an available USB Port. When connecting the logger, the USB port is
configured as a virtual COM port from 1-256 via the drivers installed. The logger is
handled by the Log-Graph software equal as a device on a serial port. This requires
the installation of Windows drivers which are located on the installation CD of Log-
Graph (installation see 2.7.3 "Installing the drivers").
The paragraphs 2.1 to 2.6 describe the properties of the logger and the software,
the paragraph 2.7 describes how to install the drivers and the software.
Properties of the logger and the software
2.1 Functional scope of the logger
The loggers 100/110 have the following properties: