User manual

3Log-Graph software
DE Dostmann Electronic GmbH
Annex
Version overview
2 Introduction
This section describes the installation of the Log-Graph software and its use in
conjunction with the loggers 100/110.
The software enables the operation of the loggers 100/110 on a PC running
Windows operating system via a vacant USB port. It undertakes the setting of the
logger and the readout of recorded data and supports all the fonctions available in
the logger. The loggers 100 and 110 are distinguishable from each other by the fact
that the first one incorporates a pure temperature sensor while the second one has a
combined temperature and humidity sensor. The logger 100 only provides raw
temperature data, the logger 110 provides both temperature and humidity data from
which the dew point is calculated. An additional external temperature sensor may be
connected to both loggers via the vacant USB port.
The logger can only be operated using the buttons Start/Stop und Mode. The setting
of the logger and the readout of the recorded data must be performed via the Log-
Graph software on the PC.