User manual

LOG100/110 – Data logger
LOG100/110 – Data logger
1716
After the completed communication with the PC do not forget to plug the
rubber cap back into the port. It prevents dirt and water from entering the
data logger.
2.7 Rear side of the data logger / battery case
On the rear side of the data logger you will find the battery case and a printed
sticker.
2.8 Replacing battery
To replace the battery please open the battery cover on the rear side. There-
fore you have to turn the battery cover 90° to the left. Remove the battery
from the instrument and replace with a new battery.
The “BAT “symbol indicates that the battery needs to be exchanged. The
instrument allows app. 24 hours of further operation after displaying the
“BAT“ symbol The battery symbol indicates according to the battery status
between 1 to 3 segments.
If the display indicates only “PF“, the battery is completely exhausted. Please
replace the battery immediately.
Attention:
Please do not dispose of old electronic devices and empty batteries in
household waste. To protect the environment, take them to your retail
store or to appropriate collection sites according to national or local regu-
lations.
Logger Battery Factory settings
is recording (total empty)
2.5 LED-Indication and Buzzer
The two LED’s and the internal buzzer help you to understand all logger
information, several status modes and alarm indications.
LED green:
The green LED flashes during the logger start and according to the measur-
ing interval if the standard settings hasn’t been changed.
LED red:
The red LED flashes when Hi- or Lo-Alarm has been achieved.
Buzzer:
The Buzzer rings when Hi- or Lo-Alarm has been achieved(if the buzzer is
not deactivated). The Buzzer also rings when the configuration has been
transferred successful from the PC to the Logger.
You can activate or deactivate both, LEDs and Buzzer by using the Software
DE-LOG-Graph.
2.6 USB-Port
For readout or programming, the data logger must be connected via USB-
cable with a PC.
View from the front: On the left side there is the USB-port. The port is pro-
tected by a small white rubber cap. To operate the USB-port please remove
the rubber cap.
DE_Log100_Anleitung 28.04.2010 10:24 Uhr Seite 9