User manual
LOG100/110 – Data logger
LOG100/110 – Datenlogger
1110
1. Introduction
Dear customer,
thank you very much for purchasing one of our products. Before operating
the data logger please read this manual carefully. You will get useful infor-
mation for understanding all functions.
1.1 General advice
• For cleaning the instrument please do not use an abrasive cleaner only a
dry or wet piece of soft cloth.
• Please store the measuring instrument in a dry and clean place.
• Avoid any force like shocks or pressure to the instrument.
• Do not use force to connect the probe or the interface plugs in. The inter-
face plug is different from the probe plug.
1.2 Before operation
• Before operating the instrument take the instrument out of the packag-
ing. Check whether a full battery CR2032 (3 Volt) is already inserted.
Display Display indication after key depression
indication FS = Factory settings
• After inserting the battery the instrument displays for 10 seconds the actual
measurements, afterwards the instrument displays for 30 seconds “FS”, after
this the instrument turn off. The same procedure appear after pressing any
button.
2.8 Batteriewechsel
•
Zum Wechseln der Batterie das Batteriefach auf der Rückseite öffnen. Dazu
wird der Batteriedeckel 90° nach links gedreht. Die Batterie entnehmen und
eine neue Batterie einlegen.
•
Das leere Batterie-Symbol zeigt an, dass Sie die Batterie in Kürze auswechseln
müssen. Sie können jetzt noch ca. 10 Stunden korrekte Messungen durch-
führen.
•
Das Batteriesymbol zeigt je nach Zustand bis zu 3 Segmente an.
•
Sollte die Displayanzeige nur „PF“ anzeigen, ist die Batterie unverzüglich zu
wechseln. In diesem Fall reicht die Batterieladung nicht mehr für Messungen
aus.
Achtung:
Bitte entsorgen Sie Altgeräte und leere Batterien nicht über den Hausmüll.
Geben Sie diese bitte zur umweltgerechten Entsorgung beim Handel oder
entsprechenden Sammelstellen gemäß nationaler oder lokaler Bestimmun-
gen ab.
DE_Log100_Anleitung 28.04.2010 10:24 Uhr Seite 6