Operating Instructions

Listening to a CD (or other auxiliary input)

1. Turn the volume knob clockwise to turn the equipment on.

2. Use the function selector to select TAPE/AUX mode, then connect the external audio

device (such as a CD player) to the AUX IN socket at the front of the equipment. The

audio signal from the external audio device will now be played through the system.

3. If an external audio device is connected to the AUX IN socket, playing of the auxiliary

device takes priority over cassette playback.

NOTE:

If you won't use the unit for a long time ,you had better take the CD out from the disk tray

door .

AUX IN encoding

1. Use the function selector to select TAPE/AUX mode and then insert a memory device

(USB drive, SD or MMC card).

2. Press the record

REC button, it will take 3 - 4 seconds to read the memory device,

then the USB or SD icon will be flashing on the LC display.

3. Press the skip up

or skip down button to select the desired mode (USB

or SD) for encoding, then press the record

REC button again to confirm.

(You can skip this step if only a USB drive or an SD/MMC card is inserted.)

4. The system will start the encoding mode after a few seconds. During encoding, the

USB or SD icon will be flashing on the display.

5. To finish encoding, press the stop

button. The display will show “END” and return

to TAPE/AUX mode.

NOTE:

 The recording speed is 1:1. Recording will take as long as playing the CD (or other

auxiliary input).

 The recording format is preset at MP3 bit rate 128 kbps.

Troubleshooting Guide

If you are experiencing problems with your USB Turntable with Cassette Deck and Radio,

check in the section below whether there are any quick and easy checks you can do that