Owner's Manual

Operation (cont’d)
11
Fill Stump Grinder
Gasoline Tank
Check the gasoline level in the grinder’s fuel tank. If needed, fill tank with
fresh unleaded gasoline from a portable container, after first reading the
warnings and instructions below.
- Do NOT fill the gas tank to the top. Gasoline may spill when operating
on a slope.
- Do NOT overfill the gasoline tank. Allow at least 1” (2.5 cm) of empty
space below the fill neck to allow for fuel expansion.
WARNING: Gasoline fire/explosion hazard
Gasoline is highly flammable and explosive. Heat, sparks, and
flames can ignite gasoline vapors, which can become widespread
during fueling. A flash fire ignition and/or explosion could result
and cause serious injury or death. The following conditions could
result in gasoline ignition/explosion:
• gas vapor collection inside enclosures
• static electric sparks
• sparks from electric wiring, batteries, or running engines
• sources of heat (such as a hot engine or exhaust)
• open flames, including pilot lights
Inspect Fuel
System / Check for
Leaks
Inspect fuel system & check for leaks BEFORE starting grinder.
WARNING: Fuel leak hazard
A leaking fuel line no matter how small can be the source of a fire or
explosion when starting or operating the engine.
• Inspect the entire fuel system. Look for: Signs of leaks or deterioration,
chafed or spongy fuel hose, loose connections, loose or missing fuel
hose clamps, damaged gasoline tank, or defective gasoline shut-off
valve.
If grinder is in an enclosed area and you smell gas, DO NOT start
engine! DO NOT light a match. DO NOT flip on an electrical
switch. Exit area immediately leaving doors open and call fire
department.
Adjust Handle Bar
Handle bar may have to be adjusted to accommodate for the height of stump
or desired depth. When grinding above or below ground level, adjust handle
bar for better control and comfort. Note: Your stump grinder should not be
used more than 10 inches (25 cm) maximum below ground.
Personal Protection
Use approved protective clothing and approved protective equipment
when using the machine.
1) Always wear ANSI-approved and OSHA-compliant (in the EU,
EN166 1F) safety glasses with side shields and a full-face shield.
2) The use of ear plugs or other hearing protection device is also
recommended for persons working within 15-20 feet (4.5–6 m) of the
running grinder for longer than a few minutes. Hearing can be damaged
from prolonged, close-range exposure to the type of noise produced by
this grinder.
3) Wear long pants to protect legs from sparks, hot engine and flying
debris.