Operation Manual

11
English
the side of the headset to put your current call on hold and answer the new call.
You can press and hold
z
/
R
at any time to switch back and forth between calls.
NOTE:
R
+ 2 is sent through the line. Your telephone line must comply with this
code to work with call waiting.
The timing of the R (recall) is set for EU standard. If the headset should be used
in France, Portugal or under PABX with other line characteristics, please change
the setting as follows:
Press and hold w until
T
/
q
/
z
on the base starts blinking.
Use MIC.
{
one base to select:
T
100ms, all European countries except France and Portugal.
q

300ms, France and Portugal.
z
600ms, New Zealand and USA.
Press wtoconrm.
Registration
Adding and registering headset
Your base can register up to two cordless headsets.
Therstregisteredheadsetwillhaveablue
O
light. When you register a second
headset to the headset base the
O
light of the headset will be orange. You
cannot register a headset if any headset is in use.
A headset can only be registered to one product at a time, so the headset must be
unregistered before registering to another headset base or cordless phone/system.
To register a headset to the headset base:
Make sure the battery is properly installed in the headset.
O
willash
twiceeveryvesecondstoindicatetheheadsetisnotregistered.
On the headset base, press and hold
J
until
z
on the headset base turns
on (about four seconds) and release the button.
Place the headset into the headset base.
Registration may take up to 30 seconds to complete.
z
on the headset base will
turn off and
O
of the newly registered headset will turn orange if registration is
successful.
If the registration is not successful,
O
ontheheadsetwillashtwiceevery
veseconds.Toresettheheadset,removetheheadsetfromthechargerandtry
the registration process again.
1.
2.
3.
1.
2.
3.