Operation Manual

10
English
Settings
q

PHONE MODE or
T
LINE MODE
There are two modes available on the headset base:
• PHONE MODE (
q

): If you are connecting to a phone via the handset or
headset outlet or using the handset lifter (sold separately) (is the default).
-OR-
• LINE MODE (
T
): with a standard analog telephone line.
To change the mode:
In idle mode, press w on the headset base to select LINE MODE (
T
) or
PHONE MODE (
q

). The corresponding light on the front of the headset base
will turn on to indicate the mode setting.
For full instructions on installing and using the handset lifter,
see the Lifter for hs1910 DECT manual.
Adaptation to different telephones
Termination
The base unit has a termination switch for adaptation to different telephone
systems. The switch can be set in different positions (A-G). If the headset does
not work, try all positions until both the receiver and sender have good sound
quality. D is standard.
Adjustment of signal amplification
If necessary the sending level (your talk) can be adjusted in 5 stages with the
MIC.
}
(down)/
{
(up) on the speech.
Volume control
The volume can be adjusted during a call with the +
v
and -
V
buttons on the
headset. A “triple beep” is heard at the highest and lowest level respectively.
Mute button
z
/
R
The microphone can be switched off/on during a call. Press
z
/
R
on the headset
to turn off the headset microphone. When mute is on, the
z
light on the headset
base will be on and a short beep will be heard every 15 seconds until mute is
turned off. Press
z
/
R
again to unmute the call.
Call waiting
If your phone line supports call waiting service, you will hear a beep if there is
an incoming call while you are already in a call. Press and hold
z
/
R
(2 sec.) on