Technical information

English
1
Important!
The earpiece of the handset may attract small ferromagnetic objects such as staples and pins, care should
be taken when placing the handset near these items.
Connection
1. Connect the curly cord to the handset and to the socket marked
q
on the side of
the telephone.
2. Place the handset into the cradle.
3. Connect the telephone line cord to the socket marked
T
on the telephone, and to
a telephone network wall socket. Lift the handset and listen for the dial tone. Your
telephone is ready to operate approximately 10 seconds after connection, the display
indicators appear after about 60 seconds.
Setting the language, clock or contrast
If you wish to set the language, clock or contrast settings, follow the steps below:
1. Press and hold
v
until the display ashes ENGLISH.
2. Select the required language using
v
/
V
. Press OK.
3. Select the desired contrast setting (3=normal) using
v
/
V
. Press OK.
4. Set the correct hour (00-23) using
v
/
V
. Press OK.
5. Set the correct minute/s using
v
/
V
. Press OK.
6. Set the correct day using
v
/
V
. Press OK.
7. Set the correct month using
v
/
V
. Press OK.
8. Select the required pause setting (2 seconds=normal) using
v
/
V
. Press OK.
The display
In standby mode the date and time, number of new and total number of calls stored
in the Caller ID memory will be displayed. Immediately following the connection of a
call, a call timer will be shown on the display.
Hearing aid compatible
This telephone is hearing aid compatible. Select the T mode on your hearing aid to
enable this feature.
Ringer
The ringer volume, melody and tone can be selected using the switches located on the
underside of the telephone behind the battery cover:
Labels/protective cover
The memory index cover can be accessed by carefully removing the transparent plastic
using a small at blade screwdriver or similar.