English AFTI 40 Hotel Telephone User guide
1 Hook switch 9 2 Mute Button 10 Direct Memory Buttons MW Indicator 3 Volume Control for Handset 11 Extension Port 4 Speaker 12 Store Button 5 Redial Button 13 Ringer Switch 6 Recall (R) Button 14 Tone/Pulse Switch 7 Speaker button and LED 15 Recall Time Selector 8 Volume Control for Speaker 16 MW Selector Switches
English Operation Connection 1. Connect the curly cord to the handset and to the socket marked q on the telephone. 2. Connect the telephone cord to the socket marked T on the telephone, and then to the telephone network socket. The modular plug will click when correctly put into place. 3. Pick up the handset and listen for the dial tone.
English Operation Mute Button The microphone is disabled while the z button is held down. Redial Button If the number dialled is engaged, or if you wish to redial the last number dialled, lift the receiver (or press the s button) and press the redial button r. Volume Controls The handset earpiece volume may be adjusted during a call using . Press the right side of the button to increase the volume, the left side to decrease it. The base speaker volume is adjusted with the control on the side of the base.
English Settings Memory This telephone has 10 Direct dialling memories. Once a number has been stored in a memory location, you need only to press one button to make the call. The store button P is located under the protective cover. Storing Direct Memory Numbers 1. Lift the handset (ignore the dialling tone) and press store button P using a pointed instrument . 2. Enter telephone number (up to 32 digits). 3. Press P again. 4. Select memory position by pressing the corresponding button. 5.
English Other Technical information Beneath the protective cover and its label are switches to select operational parametres of the telephone when connected to different types of PBX. Refer to page 5 for instructions to remove the protective cover. NB: These switches should only be adjusted by qualified personnel. Recall Button Timing There are three different Recall Button Timings available: 100/300/600 ms. Ringer Using the switch , the Ringer volume can be set to two different levels.
English Other Australia and New Zealand If you believe this product is malfunctioning, please refer to the relevant section and/or consult the troubleshooting guide in this manual to ensure that you have followed the instructions carefully. As an alternative you can visit our web site for FAQ’s or send an e-mail for a prompt reply. Guarantee This product is guaranteed for a period of 12 months from the date of purchase. Should you experience difficulties with the product, please contact us for assistance.
English Technical Support Technical information REN (RN for New Zealand) The REN (Ringer Equivalence Number) or (RN) is of significance only if you wish to connect more than 1 telephone to your telephone line. A standard telephone line has a maximum REN capacity of 3 (RN of 5). It is possible to connect 3 devices with a REN of 1 (RN of 1) with no degradation to the product’s performance. Exceeding this limit may cause the volume of the ringer in any phone to decrease or not ring at all.
English www.doro.
www.doro.
