Installation Manual

ManualsBrandsDorman ManualsAutomotiveDorman 741-823 Front Driver Side Replacement Power Window Regulator with Motor for Select Chrysler/Dodge/Plymouth Models

ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain speci c service procedures for this part. If you do not have

a service manual or lack the skill to install this part, it is recommended that you seek the services of a quali ed technician. Pay special

attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.

Disclaimer:

Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a quali ed auto

technician before attempting to perform any work you are not quali ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in

property damage or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National

Highway Tra c Safety Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.

No reproductions in whole or in part without prior written approval.

TECH NOTES: INSTALLATION

741-823

Proper installation of the regulator is

shown at right.

Note the orientation of the motor

and routing of the cable behind the

plate and between the mounting bolts.

Having the cable in this position allows

re-installation of the door panel

and smooth operation

of the window regulator.

STEP 4: For ease of installation for the

window glass to the window regulator

plastic slide, install the plastic slide clips

into the plastic slide  rst. Then press

the window glass mounting ball stud

into the plastic slide. Ball stud should

snap right into the plastic slide clip. Test

 tment prior to proceeding with the

rest of the installation.

STEP 5: The slots on the door for the

window regulator rails to mount to are

there to allow for proper alignment of

the window regulator assembly. Make

any necessary adjustments to the

orientation of the rails to ensure that

the window glass moves freely within

the window tracks, and the window

glass is correctly positioned

when fully closed.

Plastic Slide Clip