Installation Manual

1
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain speci c service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a quali ed technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a quali ed auto
technician before attempting to perform any work you are not quali ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in
property damage or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National
Highway Tra c Safety Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
©2011 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
TECH NOTES: INSTALLATION
741-823
Dodge Caravan, Chrysler Voyager and Town & Country 2001–03
NOTE: READ INSTRUCTIONS THOROUGHLY
BEFORE INSTALLATION WORK BEGINS
The following instructions describe a
technique for installing your new window
regulator. The driver’s side is shown in this
example.
STEP 1: Cut the wire tie which holds the
cable to the motor. Insert the bottom end
of the left rail through the left hole, sliding
it as far forward as possible to allow the
top of the rail to  t in.
STEP 2: Insert the top of the right rail into
the right hole. The end of the rail will slide
up between the glass and the door to
allow the bottom of the rail to be inserted.
Mount the rails to the door loosely. Attach
the glass to the regulator and adjust the
rails for proper alignment.
1
2
STEP 3: Install the three motor bolts
where the plastic OE rivets were. Ensure
that the cable crosses behind the motor
as shown and is free to slide up and
down. Cable routing is important!