Other Content

INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR
741-754
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a quali ed auto technician
before attempting to perform any work you are not quali ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Tra c Safety
Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain speci c service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a quali ed technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
3
©2012 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
STEP 2: With a trim panel removal tool, remove the interior door trim panel. NOTE: The
interior door trim panel retaining clips are roughly six (6) inches away from each other.
STEP 2a: Disconnect the connector on the backside of the master power switch assembly.
STEP 2b: If your vehicle came equipped with
a courtesy lamp built into the interior door
trim panel, please disconnect. NOTE: Not all
vehicles came equipped with courtesy lamps
built into the interior door trim panel. Some
vehicles were equipped with a re ector.
STEP 3: Once the interior door trim panel
has been removed from the door, remove
the master power switch assembly by lifting
from the door trim panel and placing the
master power switch assembly through the
hole in the interior door trim panel.
Be sure to disconnect
from switch