Other Content

INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR
741-715
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a quali ed auto technician
before attempting to perform any work you are not quali ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Tra c Safety
Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain speci c service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a quali ed technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
9
©2012 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
STEP 5: Once the glass has been attached, verify that the window regulator is operating
properly. Once it has been established that everything is functioning properly, disconnect
the window switch.
STEP 6: Install the water vapor barrier. NOTE: Be sure that all electrical connectors are
placed through their corresponding holes in the water vapor barrier.
STEP 4: Temporarily connect the power
window switch to raise and/or lower the
window regulator glass carrier. Once the
carrier is in position, remove the saddle cup
assembly, painters tape, or wedge and slide
the window glass into position. Attach the
door glass mounting hardware.
STEP 7: Attach the interior door trim panel
reinforcement bracket.