Other Content

INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR
741-715
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a quali ed auto technician
before attempting to perform any work you are not quali ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Tra c Safety
Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain speci c service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a quali ed technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
6
©2012 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
STEP 12: Temporarily connect the power
window switch to lower the door glass
to expose the window glass to window
regulator attaching screws. NOTE: The two
(2) attaching screws are di cult to access.
It may be easier to use a 10mm ratcheting
wrench to remove the mounting bolts. Once
the glass has been disconnected from the
window regulator, slide the glass into the
up or closed position. Then, hold the glass
in place with either a saddle cup assembly,
painters tape, or a wedge.
STEP 13: Remove the window regulator
assembly attaching hardware.