Other Content

ManualsBrandsDorman ManualsAutomotiveDorman 741-604 Front Driver Side Replacement Power Window Regulator with Motor for Ford Escape/Mercury Mariner

INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR

741-604

Disclaimer:

Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a quali ed auto technician

before attempting to perform any work you are not quali ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage

or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Tra c Safety

Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.

ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain speci c service procedures for this part. If you do not have

a service manual or lack the skill to install this part, it is recommended that you seek the services of a quali ed technician. Pay special

attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.

No reproductions in whole or in part without prior written approval.

STEP 5: Temporarily install the master power switch assembly.

STEP 5a: With the master power switch assembly installed, manually lower the door glass

so that you can attach the door glass to the window regulator. NOTE: It may be necessary

to operate the window regulator to align the glass attaching screws.

STEP 6: While the master power switch is still attached, operate the regulator assembly to

verify that the glass operates smoothly.

STEP 6a: After verifying that the glass is operating properly, disconnect the master power

switch assembly.

STEP 7: Verify that all of the window regulator attaching bolts are secure.

STEP 9: Align the interior door trim panel with the corresponding holes in the door.

STEP 8: Install the water vapor barrier (if so

equipped).