Other Content

INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR
741-584
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a quali ed auto technician
before attempting to perform any work you are not quali ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Tra c Safety
Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain speci c service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a quali ed technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
7
©2011 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
STEP 8: With the slider aligned with the door
frame hole, you should see a circular plastic
retainer with another smaller retainer inside
of it. This setup goes through the holes in
the Window Regulator slider as well as the
hole in the window glass to secure the glass
to the slider. The smaller pin pushes into the
larger retainer and spreads it apart to make
a tight  t against the slider and the glass. For
reference, look at the replacement Window
Regulator to visualize the slider to glass
 tment. In order to separate the window
glass from the Window Regulator slider, you
need to push the center pin out of the larger
retainer and then push the larger retainer
out of the slider and window glass. Using
a small hammer and a punch, tap the small
pin out  rst and then tap the larger pin out.
These will fall into the door frame. Retrieve
these pieces as you will need them to
reattach the replacement Window Regulator.
The Window Regulator should now be free
from the window glass.
Line slide
holes up
with
oval door
frame hole
Outer and inner
retainer pieces –
use punch to tap out
STEP 9: Use the window switch or manually
move the window glass into the full upright
position. Secure the window glass to the
door frame using tape. Painter’s tape works
well because it will not damage the door
paint or leave a sticky residue.