Other Content

INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR
741-584
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a quali ed auto technician
before attempting to perform any work you are not quali ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Tra c Safety
Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain speci c service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a quali ed technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
11
©2011 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
STEP 6: Replace the foam vapor barrier. Make sure to snap the plastic clip that was
removed back into place.
STEP 7: Reinstall the interior door handle by sliding the rear clip (away from car) into
place and then snapping the front clip in place against the door frame.
STEP 8: Reinstall the speaker by reconnecting the electrical plug and then reinstalling the
four 6mm screws that were removed
STEP 9: Reinstall the side impact bolster by lining up the three plastic retainer hooks and
then twisting clockwise to seat properly.
STEP 10: Reinstall the interior door panel by catching the top on the lip of the door frame
and then pushing downward so that the screw holes line up with the plastic blocks that
they screw into. Make sure that the window switch electrical plug is protruding through
the proper hole and is not trapped by the panel.
STEP 11: Reinstall the two 1/4” screws that go through the door handle and tighten.
Snap door handle cover in place.
STEP 12: Reconnect the window switch electrical connector and snap window switch/
door handle bezel in place. Reinstall the T-20 Torx screw that holds the bezel in place and
tighten. Snap plastic button over screw.
STEP 13: Reinstall the six T-20 Torx screws that hold the door panel to the door frame.
STEP 14: Reinstall triangular trim piece by snapping back into place.
We appreciate your opinions regarding this product!
Please call our technical assistant with any challenges or suggestions
regarding the installation or operation of this product.
1-800-523-2492