Other Content

INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR
741-584
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a quali ed auto technician
before attempting to perform any work you are not quali ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Tra c Safety
Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain speci c service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a quali ed technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
10
©2011 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
STEP 4: Move the window glass into the Window Regulator slider. Once the holes in the
slider are aligned with the plastic retainer, the glass and the slider should snap together
in place. Wiggle the window glass around making sure that they are secured. Using
the window switch, move the window up and down to make sure everything functions
properly. Lubricate the window run channels with silicone spray as you are operating the
window up and down.
STEP 5: Park the window in the full upright position and unplug the window switch. Set
window switch and bezel aside.
STEP 3: Position the window glass so that
you can access the hole in it that is used to
secure it to the window Regulator slider.
You will need to access the hole in the glass
from inside the door frame, not through the
small hole that you tapped the retainer out.
You may need to move the Regulator slider
out of the way and or move the glass into a
di erent position. If you do move the glass,
make sure to secure it before going forward.
With the glass in the position that you need,
push the pin into the larger retainer just
enough to hold it in place. Insert the retainer
into the Window glass and center it. Push the
pin all the way into the retainer to spread it
apart and hold it tight against window glass.
Make sure the retainer stays centered in
the window hole. The window glass is now
ready to be attached to the Regulator slider.
If plastic retainer is missing or damaged, a
replacement is available from Ford. The part
number is: XW4Z-54234A44-AA. The new
retainers come in one piece. You have to cut
the new one in half with a razor knife before
installing.
Outer and inner retainer pieces
Push inner pin into retainer just
enough to hold in place