Installation Manual

ManualsBrandsDorman ManualsAutomotiveDorman 741-428 Ford Truck Front Driver Side Power Window Regulator with Motor

INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR

741-428

Disclaimer:

Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a quali ed auto technician

before attempting to perform any work you are not quali ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage

or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Tra c Safety

Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.

ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain speci c service procedures for this part. If you do not have

a service manual or lack the skill to install this part, it is recommended that you seek the services of a quali ed technician. Pay special

attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.

No reproductions in whole or in part without prior written approval.

STEP 12: Temporarily connect the power switch assembly and lower the window glass,

exposing the hardware attaching the window glass to the window regulator.

STEP 12a: Using a 10mm socket and ratchet assembly, remove the screws attaching the

window glass to the window regulator. Once the window glass has been disconnected,

manually slide the window glass into the closed position and hold in place with either a

saddle cup assembly, painter’s tape, or a wedge.

STEP 13: Disconnect the power window motor.

STEP 14: Using a 10mm socket and ratchet

assembly, remove the  ve (5) window

regulator attaching screws.

STEP 15: Once the window regulator

attaching screws have been removed,

remove the window regulator through

the main access hole.