Installation Manual

ManualsBrandsDorman ManualsAutomotiveDorman 741-428 Ford Truck Front Driver Side Power Window Regulator with Motor

INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR

741-428

Disclaimer:

Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a quali ed auto technician

before attempting to perform any work you are not quali ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage

or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Tra c Safety

Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.

ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain speci c service procedures for this part. If you do not have

a service manual or lack the skill to install this part, it is recommended that you seek the services of a quali ed technician. Pay special

attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.

No reproductions in whole or in part without prior written approval.

STEP 9: Once you have veri ed that the interior door trim panel retainers have been

removed, lift the interior door trim panel in an upward motion to release the pre-molded

retainers on the backside of the interior door trim panel. NOTE: This vehicle does not use

a traditional interior trim retainer. Failure to lift the interior door trim panel completely

from the door will result in damage to the interior door trim panel.

STEP 10: Once the interior door trim panel has been removed from the door, disconnect

the interior door handle cable assembly.

STEP 8: Once the power switch assembly

has been removed from the interior door

trim panel, disconnect the power

switch assembly.

STEP 11: Remove the water vapor barrier.