Other Content

ManualsBrandsDorman ManualsAutomotiveDorman 741-307 Honda Accord Front Passenger Side Window Regulator with Motor

INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR

741-307

Disclaimer:

Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a quali ed auto technician

before attempting to perform any work you are not quali ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage

or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Tra c Safety

Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.

ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain speci c service procedures for this part. If you do not have

a service manual or lack the skill to install this part, it is recommended that you seek the services of a quali ed technician. Pay special

attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.

No reproductions in whole or in part without prior written approval.

STEP 3: Remove the rubber grommet in the

upper left-hand corner of the door frame.

Remove the vapor barrier by peeling it back.

A putty knife may help if it does not peel o

easily. Once the vapor barrier is removed, set

it aside being careful not to get the sealant

on clothes or interior of the car. It is very

di cult to remove from cloth. Sealant can

be removed from metal surfaces with some

gum cutter or a similar chemical. Check to

make sure the chemical will not damage the

paint surface.

STEP 4: Plug the window switch back

into the vehicle connector. If the Window

Regulator still operates, it is helpful to

move the Regulator up and down using the

switch. If the Window Regulator operates,

move the Window Regulator so that the two

10mm glass-to-Regulator mounting bolts

are accessible through the holes in the door

frame.

Move the Regulator so that the two glass-to-

Regulator mounting bolts are accessible through

these holes. Remove the bolts.