Other Content

3
INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR
741-307
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a quali ed auto technician
before attempting to perform any work you are not quali ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Tra c Safety
Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain speci c service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a quali ed technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
©2011 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
STEP 1c: Gently pry around switch bezel
and pop switch up out of the door handle
assembly. Use a plastic pry tool if available. It
will not easily leave marks on the trim panel.
Unplug both switch connectors.
STEP 1d: Remove the plastic trim piece
behind the interior door handle. Insert a pick
in the right-hand corner to depress the catch
and pull the piece out. Remove the two
Phillips screws.
STEP 1e: Gently pry door handle bezel away
from the door panel. Use a plastic pry tool if
available. It will not easily leave marks on the
trim panel. Pop bezel out away from panel.
Gently pry under
switch bezel
using a plastic
pry tool
Unplug switch
connectors
Depress
trim catch
Remove
Phillips
screws