Other Content

12
INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR
741-307
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a quali ed auto technician
before attempting to perform any work you are not quali ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Tra c Safety
Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain speci c service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a quali ed technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
©2011 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
STEP 20: Replace plastic triangular trim piece in upper right-hand corner by snapping
into place.
STEP 21: Operate the window up and down to make sure the window travels
smoothly and closes in the proper position.
STEP 22: Check for proper operation of auto-up and auto-down function.
STEP 23: If the window closes and opens properly but the auto-up or auto-down
function does not operate you may be able to do a simple reset procedure to activate.
This procedure is as follows:
STEP 23a: Operate the window up until it stops in a fully closed position.
STEP 23b: Hold the switch up for a few seconds after the window closes.
STEP 23c: Operate the window down until it stops in a fully open position.
STEP 23d: Hold the switch down for a few seconds after the window is stopped in an
open position.
STEP 23e: The auto features should now be activated.
STEP 24: If when operating the auto-up feature the window travels part of the way
up but then reverses on its own, you may need to complete a more involved reset
procedure. This procedure is as follows:
STEP 24a: Sit in the vehicle and close the door.
STEP 24b: Turn ignition switch to ON position.
STEP 24c: Operate the window switch so that the window travels all of the way down.
STEP 24d: Open the driver’s door.
Note: Complete steps e through h within 5 seconds of each other. Complete
these steps a total of 4 times in a row. This will clear the window switch
controls unit’s memory.
STEP 24e: Turn the ignition switch to the LOCK position.
STEP 24f: Push down and hold the window switch.