Other Content

ManualsBrandsDorman ManualsAutomotiveDorman 741-126 Ford Mustang Front Driver Side Window Regulator with Motor

INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR

741-126

Disclaimer:

Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a quali ed auto technician

before attempting to perform any work you are not quali ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage

or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Tra c Safety

Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.

ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain speci c service procedures for this part. If you do not have

a service manual or lack the skill to install this part, it is recommended that you seek the services of a quali ed technician. Pay special

attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.

No reproductions in whole or in part without prior written approval.

STEP 5: Attach the window glass to the window regulator. Manually lower the glass into

position. For ease of installation, Dorman o ers a window regulator attaching hardware

kit (the Dorman part number is 702-013). This hardware kit will include the necessary

nuts, bolts, and washers to install the window glass onto the window regulator without

the use of rivets or a rivet gun. If you choose to install with the use of rivets, you will need

a heavy duty rivet gun as well as the 1/4 “ rivets. CAUTION: IF YOU ARE INSTALLING THE

GLASS ONTO THE REGULATOR USING RIVETS YOU MUST HAVE THE RIVET SITTING FLUSH

ON THE REGULATOR. FAILURE TO DO SO WILL RESULT IN GLASS BREAKAGE.

STEP 6: Once the window glass is installed, operate the power window switch to verify

that the window regulator is operating properly.

STEP 7: Install the water vapor barrier.

STEP 4: Lower or raise the window regulator

to expose the window glass

attaching points.

STEP 8: Install the door wiring

sub-harness assembly.