Other Content

INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR
741-126
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a quali ed auto technician
before attempting to perform any work you are not quali ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Tra c Safety
Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain speci c service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a quali ed technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
6
©2012 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
STEP 10: Once the rivets have been removed manually, slide the window glass into the
closed position. Hold the glass in place with either a saddle cup assembly, painters tape,
or a wedge. NOTE: If you are using a wedge, use care around the door glass
weather stripping.
STEP 9: Once the window regulator has
been lowered (exposing the window glass
attaching rivets), attach your 1/8” drill bit to
your drill to remove the center of the rivet.
Once you have  nished this step, go up to
a 3/8” drill bit and repeat the process. Your
goal is to remove the rivet head. It may be
necessary to go up to a ½” drill bit to remove
the rivet head. CAUTION: USE EXTREME
CAUTION WHILE PERFORMING THIS STEP.
FAILURE TO DO SO WILL RESULT IN GLASS
BREAKAGE. YOUR MAIN OBJECTIVE IS ONLY
TO REMOVE THE RIVET HEAD. DO NOT DRILL
THOUGH THE RIVET, OR YOU WILL DAMAGE
THE GLASS.
STEP 11: Disconnect the window lift
motor connector.