Other Content
INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR
741-126
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a quali ed auto technician
before attempting to perform any work you are not quali ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Tra c Safety
Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain speci c service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a quali ed technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
4
©2012 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
STEP 5: Using a trim panel removal tool, place the tool between the interior door trim
panel and the door and gently pry the panel so that you can place your ngers between
the interior door trim panel and the door. At this point, you should be able to lift the
interior door trim panel in an upward motion while at the same time pulling toward you.
There are NO interior door trim panel retaining clips. This is an interference interior door
trim panel, meaning that there are keyed positions in the door to align the interior door
trim panel.
STEP 4: Using a Phillips head screw driver,
remove the interior door trim
retaining screw.
STEP 6: Once the interior door trim panel
has been removed, use your interior trim
removal tool to disconnect the door wiring
sub-harness.