Other Content

ManualsBrandsDorman ManualsAutomotiveDorman 740-692 Front Driver Side Power Window Regulator

INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR

740-692

Disclaimer:

Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a quali ed auto technician

before attempting to perform any work you are not quali ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage

or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Tra c Safety

Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.

ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain speci c service procedures for this part. If you do not have

a service manual or lack the skill to install this part, it is recommended that you seek the services of a quali ed technician. Pay special

attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.

No reproductions in whole or in part without prior written approval.

Installation Instructions

STEP 1: Verify that the drive gear on the window lift motor and the sector teeth on the

regulator are lubricated.

STEP 2: Snap the window lift motor into position on the window regulator module

assembly.

STEP 3: Attach the window regulator onto the window regulator module assembly.

IMPORTANT: Be sure to line up the grease pencil or marker line from the removal

procedure. Lining up the mark will set the proper amount of pre-tension on the

counterbalance spring tensioner.

STEP 4: Attach the counterbalance spring

tensioner onto the window regulator

module assembly.

STEP 5: Attach the window regulator door assembly onto the door.

STEP 6: Attach the bolts to the door glass. Be sure not to overtighten the bolts.