Other Content

INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR
740-679
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a quali ed auto technician
before attempting to perform any work you are not quali ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Tra c Safety
Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain speci c service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a quali ed technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
4
©2011 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
STEP 5: Once the door trim panel has been
removed, remove the water vapor barrier.
STEP 6: Using a trim panel removal tool
or the  at side of a tool handle, press the
window lift motor connector into the door.
NOTE: Do not disconnect at this time.
STEP 7: Lower the door glass so that you can remove the two bolts attaching the window
glass to the window regulator.
STEP 7a: Once the door glass is separated from the window regulator, hold the door glass
in the up position with either a saddle cup assembly, tape, or wedge.