Installation Manual

INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR
740-178
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a quali ed auto technician
before attempting to perform any work you are not quali ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Tra c Safety
Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain speci c service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a quali ed technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
5
©2012 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
STEP 11: Once the door glass has been separated from the window regulator, manually
slide the door glass into the closed position and hold in place with a saddle cup assembly,
painters tape, or a wedge.
STEP 9: Disconnect the interior door handle
by using a medium  at-blade screwdriver
and prying up on the regulator to release
the door handle shaft. NOTE: Do not worry
if you break the mounting tab o of the
regulator. The new regulator is equipped to
use the original door handle.
STEP 10: Temporarily connect the window
switch to lower the door glass, exposing the
two (2) bolts mounting the door glass to the
window regulator. You will be using a 10mm
socket with extension and a ratchet.