User Manual

599-210
1
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specic service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a qualied technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
TECH NOTES: INSTALLATION
©2015 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a qualied auto technician
before attempting to perform any work you are not qualied to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Trac Safety
Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
Cadillac 2006–03, Chevrolet 2009–02, GMC 2009–02, Buick 2007–04,
Isuzu 2008–03, Oldsmobile 2004–02, Saab 2009–05
This climate control module consolidates
OEM modules that are used in vehicles with
rear defrost, and ones that do not have rear
defrost. For vehicles that have rear defrost,
the unit may be installed as is. For vehicles
that do not have rear defrost, you must rst
install the blank button included with the
module by following the steps below.
Insert a small screwdriver in the slot on the
bottom half of the rear defrost button. Lift
up on the button and it will easily detach
from the module.
To install the blank button, insert a athead
screwdriver through the rectangular slit
located at the bottom of the faceplate and
push up on the button housing. At the same
time, take the blank button and press it
down on the button housing, until it clicks
into place.