Installation Guide

9ICU300 / ICU300T 05-2022DL3107-020
ICU300 / ICU300T Manual Sliding Doors
Track Installation Instructions
7
Hanging the “SX” or “SX2” panel
1
2 Find the highest spot along track. Place small screwdriver below “SX” pivot, loosen set screw and re-tighten when “SX”
bottom guide pin reaches screwdriver (1/8” Allen required).
3 Align track with jamb. Fasten and anchor bottom track to floor.
Lift ”SX” or “SX2” panel and place rollers onto roller track in header.
2
1/4-20 Set Screw
3
Note: Pin should not touch bottom
of track during slide operation.
When installing a telescopic unit, you must adjust door height completely before proceding to next step
1
4 Adjust “SX” or “SX2” panel (refer to page 11).
4