Installation Guide

13ICU300 / ICU300T 05-2022DL3107-020
ICU300 / ICU300T Manual Sliding Doors
Track Installation Instructions
Adjustment of the Breakout-Unit
1. Loosen the set screws (a ,b&c)toprevent interference while adjusting door. (7/32” Allen wrench required.)
2. Use the adjustment screw (d) to lift (CW) , or lower (CCW) , the leading edge of door.
4. Tighten all set screws (a, b & c) until tight and secure.
Recheck the latched position alignment and readjust as necessary.
3. Continue adjustment until the re-latch profiles are properly aligned.
11
3
Note: It may be necessary to temporarily move
deadstop bracket out of the way to access
adjustment screw “d”.
1/8” Allen wrench required.
ab c
d