Installation Guide

10 ICU300 / ICU300T 05-2022DL3107-020
ICU300 / ICU300T Manual Sliding Doors
Track Installation Instructions
(1/8” Allen required).
2
1
5 Align track with jamb. Fasten and anchor bottom track to floor.
Install outer roller track by fastening into masonary opening.
Hanging the “SX1” panel for telescopic 3 leaf and 6 leaf units
8
1/4-20 Set Screw
Note: Pin should not touch bottom
of track during slide operation.
3 Find the highest spot along track. Place small screwdriver below “SX1” pivot, lossen set screw and re-tighten when “SX1”
bottom guide pin reaches screwdriver (1/8” Allen required).
2 Lift “SX1” panel and place rollers onto outer roller track.
4 Adjust “SX1” panel (refer to Page 11).
2
4
3
5
Outer roller track
1