Operation Manual

‐ 5 ‐

2. When swiping card in card wiping area, card number will be displayed and when the whole screen is
occupied, screen will be cleared automatically.

2.5 ． Operation introduction to NewHIDDemo

1. Click the icon of NewHIDDemo application program to enter into the application program interface.

2. When swiping card in card wiping area, card number will be displayed.


2.6 ． Operation introduction to NewWiegenDemo

1. Click the icon of NewWiegenDemo application program to enter into the application program interface.

2. Default as Weigen26, connect Weigen26 read head to bottom left in rear of the machine; when swiping
card in card wiping area, card number will be displayed.
3. Connect Weigen34 read head to bottom left in rear of the machine, click Weigen26 bit to convert into

Weigen34; when swiping card in card wiping area, card number will be displayed.


2.7 ． Operation introduction to Otg mode change

1. Click the icon of Otg mode change application program to enter into the application program interface.

2. Click the button to switch the status of usb interface (status includes usb device and usb host).

When usb interface is in usb device status, usb interface can be used for program debugging;
When usb interface is in usb host status, usb interface can be connected with usb disk.
2.8. FCC Statement

This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
NOTE:
The manufacturer is not responsible for ANY interference, for example RADIO or TV interference,
caused by unauthorized modifications to this equipment. Such modifications could void the user’s
authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.If this equipment does