Operation Manual




2. Anti-dumping alarm status is displayed at the first item in the application program interface. When the
anti-dumping alarm switch in rear of the machine is pressed, this item will display “(on)”, which means
alarm is triggered.
3. The second item in the application program interface is used to operate LED RED. When this button is
pressed, the button turns red and LED RED is on; when this button is pressed again, LED RED will be off
automatically.
4. The third item in the application program interface is used to operate LED GREEN. When this button is
pressed, the button turns red and LED GREEN is on; when this button is pressed again, LED GREEN will
be off automatically.
5. The fourth item in the application program interface is used to display the door sensor status, for the
color of that button will change with the change of door sensor status.
6. The fifth item in the application program interface is used to display the out switch status, for the color
of that button will change with the change of out switch status.
7. The sixth item in the application program interface is used to control the lock status, when the button is
pressed, the relay will make the lock at " (on) " status, when the button is pressed again, the lock will be at
" (off) " status.

2.4 ． Operation introduction to IClass

1. Click the icon of IClass application program to enter into the application program interface. Open serial
port success will be displayed.
‐ 4 ‐
