Service manual

3.3 Mounting one Kingston Data-Express removable drive system

♦ Disconnect all cables including power from the back of the V1

♦ Prepare your Kingston receiver according to one of the following diagrams:

♦ Install the hard drive in the carrier (See Sections 0, 0, 0 for setup), connect the SCSI Id cable

supplied (black/brown/red) to the correct jumpers on the hard drive (Check also the direction).

♦ Install the receiver on the bottom V1 tray.

♦ Connect SCSI and power to the Data-Express.

♦ Power ON the V1 and set the SCSI ID of the Data-Express to ID3 (screw on the right hand side

of the receiver) using the screwdriver provided with the Data-Express. For more detail refer to

the Data-Express manual.

♦ Execute a Format command followed by an Initialize command.

W3 W1 W2

A B

J6 J6A

If you dont see 3

terminator resistors

(SIP) use this jumper

setting

Rear View of the

Kingston Receiver

W1 W2

B A

J4 J7

If you see 3 terminator resistors

(SIP) remove them and use this

jumper setting

Rear View of the

Kingston Receiver

68 PIN SCSI CONNECTOR

J6 J6A

50 PIN SCSI CONNECTOR