Service manual

2 Replacing the Power Switch

♦ Disconnect the power connector from the back of the V1 very important.

♦ Pull out the power switch from the front.

♦ Mark the direction of the switch (O to the right) and mark the colors of the wires.

♦ Remove all four connectors after marking the way they were connected.

♦ Install the four connectors on the new power switch:

-Black and brown horizontally aligned.

-Blue and white horizontally aligned.

CAUTION NOTE: FOR VENTILATION PURPOSES, THE OPENEING OF THE TOP COVER

SHOULD ALWAYS BE TOWARDS THE HARD DISK TRAYS AND NOT TOWARDS THE

POWER SUPPLY. ALL INTERNAL CABLES SHOULD BE PLACED AT LEAST ONE INCH

ABOVE THE CIRCUIT BOARD, USE CABLE TIES IF NECESSARY.