Service manual

18
INSTRUCTIONS FOR INITIAL SETUP & TRANSPORT
IMPORTANT !!
♦ Before powering-up the V1 unit, please connect the SCSI termination supplied on the rear
external SCSI connector (If not there, the V1 will not operate properly).
♦ After powering-up, if your V1 has been ordered with a drive from Doremi Labs, you will be
able to play the initial "video test" recording (In NTSC for USA, PAL for Europe) without
the need of an external sync reference (Internal Sync. selected). If you need to play locked to
House Sync, connect a Black Burst signal to the SYNC IN connector and go to menu (02)
"Sync from", select the option Sync In and validate by pressing ESC.
♦ Before turning the V1 OFF, please eject all JAZ cartridges.
♦ Before any transport :
♦ Please eject all JAZ or MOD cartridges and remove them.
♦ Lock the Data-Express (Key ON as for normal use).
♦ Switch the V1 OFF.
♦ Remove the SCSI termination on rear (Leaving it may break the SCSI connector
during transport ).