Service manual

10
3.4 Mounting two Kingston Data-Express removable drive systems
♦ Repeat the procedure C. for both frames. Set the bottom tray to ID3 and the top one to ID 4.
3.5 Mounting one Jaz and one Kingston Data-Express removable system
♦ Repeat procedure A. for the Jaz, set it to ID4 and install it on the top V1 tray.
♦ Repeat procedure C. for the Data-Express, set it to ID3 and install it on the bottom V1 tray.
3.6 Setup of the Fast SCSI Seagate Barracuda4 hard drive ST15150N
(Obsolete drive)
These are the two connectors that should be configured on the ST15150N:
T
P
F
R
O
M
B
U
S
T
h
i
s
i
s
t
h
e
o
n
l
y
j
umper that
should be
installed on J01
P
I
N
1
P
O
W
E
R
CONNECTOR
J
0
1
J
4
R
e
d
,
B
r
o
w
n
&
B
l
a
c
k
wires on LEFT
T
o
D
a
t
a
-
E
x
p
r
e
s
s
B
R
N
R
E
D
B
L
K
R
e
a
r
V
i
e
w
J01 should only have one jumper to set the termination power from SCSI bus. That position is marked in
the drawing above.
The Data-Express carrier should be connected to the drive with 3 cables:
1. Power Cable
2. SCSI Cable
3. SCSI ID number cable: this cable is supplied by Kingston with the Data-Express and has one 3 pin
connector that connects to the Data-Express carrier, and three 2 pin connectors that should be
connected to the drive. Note that each of those 3 wires are connected to only one side of the 2 pin
connector, that side with the wire should be connected to the left row of J4 if you are looking straight to
the back of the drive.
Extra care should be given as to not have cable number 3 described above be caught between the drive and
the Data-Express carrier chassis.