User`s manual

14.3 Mounting Data-Express on all V1 DCT products except V1x2

♦ Disconnect all cables including power from the back of the V1

♦ Prepare your Kingston receiver according to one of the following diagrams:

♦ Install the hard drive in the carrier (See Sections, Error! Reference source not found. for

setup), connect the SCSI Id cable supplied (black/brown/red/orange/yellow) to the correct

jumpers on the hard drive (Check also the direction).

♦ Install the

receiver on the bottom V1 tray.

♦ Connect SCSI and power to the Data-Express.

♦ Power ON the V1 and set the SCSI ID of the Data-Express to ID4 (screw on the right hand

side of the receiver) using the screwdriver provided with the Data-Express. For more detail

refer to the Data-Express manual.

♦ Insert the Data Express carrier holding the drive in the receiver.

♦ Turn the Data Express key counter-clockwise to power on the drive

W3 W1 W2

A B

J6 J6A

If you dont see 3

terminator resistors

(SIP) use this jumper

setting

Rear View of the

Kingston Receiver

W1 W2

B A

J4 J7

If you see 3 terminator resistors

(SIP) remove them and use this

jumper setting

Rear View of the

Kingston Receiver

68 PIN SCSI CONNECTOR

J6 J6A

50 PIN SCSI CONNECTOR

DE100i-RSW/B