User`s manual

13.11 List of DAWs & Editors currently supported by the V1

(*)

Adams-Smith SuperController, Akai DD1500, AMS Neve Audiofile, Augan OMX, DAR, Digidesign

Protools 4.0, Digigram X-Track, Doremi Labs Dawn II v. 4.3+, Fairlight MFX3, Fast Video Machine,

Sadie, Sonic Solutions, Sony BVE, Spectral, Studer Dyaxis, SSL/Screensound, Synclavier, TimeLine

Vista Waveframe/StudioFrame, TimeLine Lynx & Micro Lynx Synchronizers .

Special note for the SSL/Screensound :

On the Screensound, go into the page 'Setup Serial' and select 'Motion Off'. The V1 will be controlled by

the Screensound. The offset on the Screensound must then be set to 0; if not the Screensound will operate

as if a real offset is present between the V1 and the audio tracks on the Screensound.

The V1 can be used with virtually all systems that have the ability to control video machines

through serial Sony 9 Pin protocol like SSL Consoles, Euphonix consoles, Slow-Motion Controllers,

Desktop Remote Controllers....

See note 12.4 about the V1 RS422 protocol identification.

(*)

This list is not absolute, contact Doremi Labs if your product is not listed above

13.12 Using the V1 with Edit Controllers

These notes are written specifically for the RM450 Edit Controller, but most of the settings and

recommendations should be the same regardless of the Edit Controller used.

Player: CTL and 9pin

Preroll: 5

Synchro: ON (according to their documentation the ON/CF mode uses color frame information to

synchronize but the precision of the edit is lower. The best precision is when Synchro is ON)

Recorder: CTL and 9pin

When you use a V1 on the player or on the recorder the setting of the RM450 should be in CTL mode

and the V1 should be either in A-Time or A-Time As LTC. The V1 will not work properly if the switch

is set to TC.

The DIP switches:

Left side: All OFF

Right Side: All OFF except bit number 2 which sets the edit time to 4. Do not use the default setting,

which is Auto mode.

On the V1 side, the recorder should be set to: Edit IN=4 and Edit OUT=4 and the unit should be in Frame

Mode=ON

This will allow the Edit to happen only on frames and the IN and OUT points will be accurate.

Other settings on the V1:

Emulation =BVW-75

Mode =Remote

Time Mode =A-Time or A-Time in LTC

Sync Source: Sync IN