User`s manual

47
8 Upgrading the RCV2 firmware
All silver V1 decks have two firmwares, one for the V1 motherboard and another for the front panel (the
RCV2).
8.1 Checking your RCV2 firmware version
Enter the Controller Menu by holding the ESCAPE button and pressing MENU. Scroll to Firmware.
8.2 The VUploader utility
The RCV2 can be upgraded using the VUploader utility version 1.08 or higher. Download the VUploader
utility from www.doremilabs.com
in the support page.
Connect the 9pin cable between the RCV2-9P port labeled RS422 (1-2) (do not use the port labeled
RS422 (3-4)) to any of the ports on the back panel of your V1 deck.
Check that your V1 is running firmware version 4.16c or higher. If not use VUploader to upgrade it first.
Power up the unit while holding the Channel 1 button under the 4 line LCD display, you should see a
message saying "Flash mode"
Run VUploader. For detailed instructions see the VUploader README file that comes with VUploader.
When you receive the message from VUploader asking to select a port, choose the RS422 port that you
connected to on the back of the V1.