User`s manual

39
Select Channel 1. Go to the start of the disk by pressing CLEAR
then press GOTO, then start recording.
Select Channel 2 and press the Record button to go in EE mode.
When you see an event worth marking press SAVE, this will
increment the Clip number and save the IN point of the clip
minus the Preroll value setting. (see Preroll above)
Every time you hit SAVE, the clip number will increment and
the new time code will be captured.
If you want to recall a specific segment press the ++ or – buttons
until you see the desired clip number displayed, then press
RECALL. (You can do this while in EE mode)
When you press SloMo, the unit will start playing from that point
at the slow motion speed selected by the Shuttle wheel.
To stop and go back in EE, press STOP followed by the RECORD
button.
Default is “off”.
(07) Gang Mode Dual-channel V1 only or control of two single channel V1
decks. When ON, it will insure that both channels are always at
the same time code location. Used to synchronize the recording
and playback operation of two channels. Default is “off”.
(08) 4224 Clip Mode Dual-channel V1 only or control of two single channel V1
decks. For applications such as logo insertion plus key. This mode
was created so people can record Logo plus Key separately, then
find the in points and make clips that are locked together.
In this mode the RCV2 will insure that all clips are created with the
same duration on both channels, the only distinction is that the IN
and Out points will be different.
Define the IN and OUT on Channel 1, then define the IN only on
channel 2 and hit SAVE clip# ENTER. The RCV2 will
automatically calculate the duration from channel 1 and create an
equal length clip on channel 2. When you RECALL clip# ENTER,
the unit will play both clips synchronously even if they don't have
the same start time. Default is “off”.