User`s manual

37
The V1 will also send a trigger to output pin 1, pin 2 or pin 3 after it
completes the playback of a segment. The pin number is determined by the
remainder value when dividing the segment number by the number three.
(34) Set IP Allows the user to change the IP address of the V1. To enter a new IP address,
type it in 3 digit blocks. To jump from one block to the other hit the BKSP. If you
are using the RCV2 front panel, you can hit CLEAR before typing the IP address.
When you are done entering the new IP address you need to hit ENTER, then
save the new IP to flash using Option Menu 4. You need to restart the unit to use
the new IP address.
(35) HD I/O >>UncompHDTV ONLY Select between “non segmented” and “segmented”
frame. When set to segmented frame the V1-UHD will record and output
segmented frame HD video (sf).
(36) Record At This menu option allows you to quickly set the V1 to begin recording at the end
of the drive where no video material has been recording. Thus preventing you
from accidentally recording over existing video. Select between “Record at
Current Position” and “Record at End of File”