User`s manual

35
in option menu (8). If the clip selected in Option Menu 8 is 0, the loop will be on
the whole disk space.
(23) Edit Time The “++” key will switch between IN and OUT. When using the EDIT ON/OFF
commands from a P2 editor
EDIT IN 2, 3, 4 or 5 frames. Pressing TOGGLE specifies the number of
frames the V1 will wait before it starts recording after receiving
an EDIT ON command. For MPEG2 units this should be set to 5.
EDIT OUT 2, 3, 4 or 5 frames. Pressing TOGGLE specifies the number of
frames the V1 will wait before it stops recording after receiving
an EDIT OFF command. For units this should be set to 5.
(24) Stripe TC This command will stripe Time Code with black video and no audio. The striping
will start at the time line position starting with the time line displayed on the
LCD. Example: If you want to stripe time code beginning at 01:00:00:00, you
would: Initialize your drive. Create a one hour offset using the OPTION IN
command. Then use this Option Menu command by pressing the “++” button. The
LCD will reply: "Are you sure". If you are, hold the OPTION Key and press the
TOGGLE button, if not just hit the ESC key.
(25) Odd Fields The speed shown in percentage after the word “Under” will define the speed
under which the V1 will only play odd fields. If you want to play odd and even
fields at all speed, use the TOGGLE key to select 0%. For Slow Motion
applications you must set this parameter to “0” and save it.
(26) Stop Chase The number of frames defined in this option menu will set the free-wheel of the
chase mode between 1 and 10 frames or “0”. When set to “0”, the V1 will play
the same field for the whole duration of the time code drop-out. When set to a
value between 1 and 10, the V1 will play the same field for the specified amount
of frame(s) before it stops and wait for the new time code to chase. This function
is useful to reduce the audio noise during the chase command. If you know that
your source does not have drop-outs in the time code, set this value to 1.
(27) Fast Mode Select between normal and enhanced. Enhanced mode will provide the best video
preview in Fast Forward and Fast Rewind
- Set Fast Mode to Enhanced on all single channel units, the V1x2 with dual-
drives and the V1-MP2 in one channel mode.
- Set to Normal for units connected to the V1Xserver and multi-channel units like
the V1x2-1r2p, V1MP2-1r2p, V1-UHD-1r2p.
(28) Jog Speed Sets the maximum speed in Jog mode to 100% or no limit.
(29) Still Mode Sets the mode of the V1 stop mode to either show a field/frame from the drive
(Still) or show the image present on its input (EE). In EE mode, pressing Stop
more than once will show the image from the drive.
(30) File Type The use of this Option Menu is necessary to define the SCSI ID of the active disk
and to create a file system that uses multiple disks (RAIDSET) in the Multi File
system mode. The selections are:
Single File or
Multi File
See Section for definition of Single file and Multi-file systems.
>For DCT and MPEG-2 use Single File (SFS)
>For Uncompressed use Multi File (MFS) or see UncompSD
note below.
Disk-1
Sets the SCSI ID of the active disk (Single File) or SCSI ID of
the first disk in the RAIDSET (Multi File)